Rear Right Coolant Pipe: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to COOLANT PIPES OVERVIEW .

Installation is in reverse order of removal, note the following:

NOTE:

Secure all hose connections with hose clamps appropriate for the model. .

During installation, all cable ties must be installed at the same location.

-- Install throttle valve control module -J338-. Refer to COMPONENT LOCATION OVERVIEW - FUEL INJECTION SYSTEM .

-- Install crankcase ventilation pressure regulator valve. Refer to COMPONENT LOCATION OVERVIEW - FUEL INJECTION SYSTEM .

-- Fill with coolant COOLING SYSTEM, DRAINING AND FILLING .