Rear Coolant Pipe: Installing

WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to COOLANT PIPES OVERVIEW .

Installation is in reverse order of removal, note the following:

NOTE:

Replace gaskets and O-rings.

Secure all hose connections with hose clamps appropriate for the model. .

During installation, all cable ties must be installed at the same location.

-- Clean and/or smooth O-rings sealing surface before installing.

-- Coat new O-rings with non-corrosive lubricant (Vaseline), install rear coolant pipe and tighten.

-- Install throttle valve control module -J338-. Refer to OVERVIEW - INTAKE MANIFOLD .

-- Install crankcase ventilation pressure regulator valve. .

-- Fill with coolant COOLING SYSTEM, DRAINING AND FILLING .