Removal And Installation: Radiator: Installing
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specifications. Refer to RADIATOR OVERVIEW .
Installation is in reverse order of removal, note the following:
-- Connect the coolant hose with the connector coupling. Refer to Figure.
-- Install refrigerant lines. Refer to Removal and Installation .
-- Install fan shroud. Refer to FAN SHROUD .
-- Tighten ATF lines. Refer to ATF LINES AND ATF COOLER, REMOVING AND INSTALLING .
-- Fill with coolant COOLING SYSTEM, DRAINING AND FILLING .
NOTE:
Complete coolant must be replaced if the radiator was replaced.
-- Check ATF level. Refer to ATF LEVEL, CHECKING AND FILLING .