Radiator Overview
WARNING: This page is about a different car, the 2010 Audi Q7, 2009 Audi Q7, 2008 Audi Q7, and 2007 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 8 Nm
- Clamp
- Make sure it is secure.
- ATF Cooler
- For the automatic transmission.
- Condenser
- For air conditioning system.
- Clamp
- Make sure it is secure.
- Washer
- Rubber Buffer
- Radiator
- Removing and Installing, refer to RADIATOR, REMOVING AND INSTALLING .
- Change the coolant after replacing.
- Grommet
- Bolt
- 5.5 Nm
- O-Ring
- Replace
- Clamp
- Engine Coolant Temperature Sensor on Radiator Outlet -G83-
- O-Ring
- Replace
- Coolant Hose
- Connect to the radiator, refer to Fig 2.
- Coolant Hose
- Coolant Hose
- Connect to the radiator, refer to Fig 2.
- O-Ring
- Replace
- Bolt
- 8 Nm
- Bolt
- 8 Nm
- Clamp
- Make sure it is secure.
- Hydraulic Fluid Cooler
- For power steering.
-- Remove the old o-ring -2- in the coolant hose -3-.
-- Moisten new O-ring with coolant additive and install it in the coolant hose.
-- Press the coolant hose onto the radiator -1- or coolant pipe until it engages.
-- Press the coolant hose on again and pull to make sure the connection is engaged correctly.