Ribbed Belt TENSIONER, Removing And Installing

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Removal

Fig 1: Identifying Bolt -1 And 2- To Ribbed Belt Tensioning Element

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ribbed belt from the tensioner. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the bolt -1- and -2- and then remove the ribbed belt tensioning element.

Installation

Install in reverse order of removal. Note the following:

Tightening specification. Refer to RIBBED BELT DRIVE OVERVIEW .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .