SCR Catalytic Converter

Removing

-- On a vehicle with air suspension, activate vehicle lift mode. Refer to the appropriate service information .

-- Disconnect the exhaust system at the clamping sleeve -arrows-.

Fig 1: Disconnecting Exhaust System At Clamping Sleeve -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Remove NOX sensor 2 -G687- -3-.

-- Disconnect the connector -5-.

Fig 2: Disconnecting Connector -5-

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamp -arrow- and remove the reducing agent injector -N474-.

-- Move the nuts -1- and bolts -2- and -4- and remove the SCR catalytic converter.

Installing

Install in reverse order of removal. Note the following:

-- Install the reducing agent injector. Refer to Reducing Agent Injector -N474- .

-- Install the NOx sensor 2. Refer to Removal and Installation .

-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to the appropriate service information .