Left Exhaust Manifold
Special tools and workshop equipment required
- Hose Clamps Up to 25 mm Dia. 3094
- Engine Bung Set VAS 6122
Removing
-- Remove the left intermediate pipe. Refer to LEFT INTERMEDIATE PIPE .
Place a cloth underneath to soak up any escaping power steering fluid.
Vehicles Built through 05.10:
-- Disconnect the power steering pump hydraulic hose and the 3094.
-- Loosen the hose clamp -1- and remove the power steering fluid hose.
Ignore -2-.
-- Remove the banjo bolt -1- and bolt -2- and lay the power steering fluid line to the side.
Vehicles Built from 06.10:
Place a cloth underneath to soak up any escaping power steering fluid.
-- Clamp off the power steering pump hydraulic hose -1- with a 3094.
-- Remove the bolts -2- and move the hydraulic line to the rear.
All Vehicles:
-- Seal the open lines and connections with clean plugs from the VAS 6122.
-- Remove nuts -arrows- and remove the exhaust manifold.
Installing
Install in reverse order of removal. Note the following:
- For the correct tightening specifications, refer to EXHAUST MANIFOLD OVERVIEW .
Replace the seals, O-rings and the self-locking nuts.
Secure all hose connections with hose clamps appropriate for the model.
-- Install the power steering fluid line. Refer to Description and Operation .
-- Install the left intermediate pipe. Refer to LEFT INTERMEDIATE PIPE .