Exhaust Gas Temperature Sensor 4

Removing

-- On a vehicle with air suspension, activate vehicle lift mode. Refer to the appropriate service information .

-- Carefully pull the engine cover -arrows- off the 4 bolts one after the other.

Fig 1: Identifying Engine Cover -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and -2- and then remove the heat shield from the turbocharger.

Fig 2: Identifying Bolts -1 To 2- And Turbocharger Heat Shield

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the exhaust gas temperature sensor 4 -G648- brown connector -4-.

Fig 3: Component Location On Plenum Chamber Bulkhead

Courtesy of AUDI OF AMERICA, LLC

-- Free up the electrical wire.

NOTE:

Ignore -1, 2 and 3-.

-- Remove the noise insulation -1- and -2-. Refer to the appropriate service information .

Fig 4: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove and free up exhaust gas temperature sensor 4 -arrow-.

Fig 5: Identifying Exhaust Gas Temperature Sensor 4 -Arrow-

Courtesy of AUDI OF AMERICA, LLC

Installing

Installation is performed in reverse order of removal, noting the following.

-- Coat the exhaust gas temperature sensor thread with hot bolt paste.

-- Install the noise insulation. Refer to the appropriate service information .

-- Install the turbocharger heat shield. Refer to TURBOCHARGER OVERVIEW .

-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to the appropriate service information .