Exhaust Gas Temperature Sensor 1

Removing

-- Carefully pull the engine cover -arrows- off the 4 bolts one after the other.

Fig 1: Identifying Engine Cover -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- and -2- and then remove the heat shield from the turbocharger.

Fig 2: Identifying Bolts -1 To 2- And Turbocharger Heat Shield

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the -1- exhaust gas temperature sensor 1 -G235- black connector and free up the wire.

Fig 3: Identifying Connectors -1 And 2-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -2-.

-- Remove the exhaust gas temperature sensor 1 -arrow-.

Fig 4: Exhaust Gas Temperature Sensor 1 -G235- -arrow-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To provide a better illustration, component location is shown from behind with engine removed.

Installing

Install in reverse order of removal. Note the following:

-- Coat the exhaust gas temperature sensor thread with hot bolt paste.

NOTE:

During installation, all cable ties must be installed at the same location.

-- Install the turbocharger heat shield. Refer to TURBOCHARGER OVERVIEW .