Coolant Pump
Special tools and workshop equipment required
- Spanner Wrench 3212
Removing
-- Drain the coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .
-- Remove the ribbed belt from the tensioning element. Refer to RIBBED BELT .
-- Tilt the toothed belt guard forward -arrows- and disengage the pins on the underside of the guard.
The toothed belt guard is shown with the intake manifold upper section removed.
-- Using a 3212 as a counterholder, remove the bolts -arrows- and remove the coolant pump ribbed belt pulley.
-- Remove the bolts and remove the coolant pump -arrow-.
Installing
Install in reverse order of removal. Note the following:
-- Clean the sealing surface.
-- Tighten the coolant pump bolts. Refer to Figure.
-- Install the ribbed belt. Refer to RIBBED BELT .
-- Fill with coolant FILLING .