Release Cable

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hood Release Cable Overview

Courtesy of AUDI OF AMERICA, LLC

Lid Latch
- Removing and Installing. Refer to Cable Coupling .
- To adjust the hood, slide up or down.
Hood Cable
- Removing:
  -- Disconnect the release cable at the coupling. Refer to Cable Coupling .
  
  -- Disengage the release cable from the bracket -7-.
  
  -- Pull the release cable through to the engine compartment.
- Installing: install in reverse order of removal
Cable Coupling
-- Slide the coupling clamp sideways onto the bracket -8- on the lock carrier.

-- Disconnect the release cable here before removing the lock carrier and release lever.
Hood Lock Rear Cable
- Release cable to the operating lever in the vehicle interior.
Grommet
- Make sure it fits correctly when installing.
Operating Lever
- Disengage the release cable. Refer to Hood Release Lever, Removing .
Lid Lock Release Lever
- Operating lever cover, removing. Refer to Release Lever Cover, Removing .
Lock Carrier
Wire
- Pull the electrical wire and the lid lock cable through the lock carrier as shown.
Clip
- Slide the clamp with the electrical wire onto the tab in the lock carrier.