LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> Q5 3.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 530 (Exterior Body Panels (Hood, Lids) (Sedan)) >> (55 Hood, Lids) >> Hood >> Hood Release Lever, Removing And Installing >> Hood Release Lever, Removing

Hood Release Lever, Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Hood Release Lever
GWWA55-10302Courtesy of AUDI OF AMERICA, LLC
  1. Release Cable
    • Clip the cable bracket into the mounting bracket as shown in the magnified section of the illustration.
  2. Hood Release Lever Bracket
    • The hood release lever cover is removed.
    • The trim for the >>lower A-pillar is removed<<.
    • Remove the screws -3- and disengage the cable -1-.
  3. Bolts
    • 2 Nm
  4. Clip
  5. A-Pillar
scientia non olet · About LEMON Manuals