Overview - Supercharger

Fig 1: Identifying Supercharger Overview

Courtesy of AUDI OF AMERICA, LLC

Engine Lifting Eye
Bolt
- 27 Nm
Compressor
- With charge air coolers
- Supercharger, Removing and Installing, refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Charge Air Cooler Assembly Overview, refer to OVERVIEW - CHARGE AIR SYSTEM .
- Secure for work on the Engine And Transmission HolderVAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .
- Secure for leak test on the Engine And Transmission HolderVAS6095, refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAKAGE TEST .
Insulation Plate
Bolt
- 5 Nm
Rubber Grommet
- Quantity: 2
Intermediate Flange
Bolt
- Tightening specification, refer to Fig 2.
Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
O-Rings
- Replacing
Connection
Bolt
- Tightening specification and sequence, refer to Fig 3.
Bracket
- For change-over valves
Bolt
- 9 Nm
Bolt
- Tightening specification and sequence, refer to Fig 3.
Intermediate Flange
Control Valve Control Unit -J808-
- Removing and installing, refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
Bleed Screw
- 1.5 to 3.0 Nm
- For the left charge air cooler
Bolt
- Tightening specification, refer to Fig 5.
Intake Air Temperature Sensor -G42-
- Removing and installing, refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
O-Rings
- Replacing
Nut
- 20 Nm
O-Ring
- Replacing
Threaded Pin
- 17 Nm
Bolt
- 10 Nm
- Replacing
- Self-locking
- always clean the threaded holes with a thread tap before assembling
Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing, refer to CHARGE AIR PRESSURE SENSOR -G31- / -G447-, REMOVING AND INSTALLING .
Seals
- Replacing
O-Ring
- Replacing
- Quantity 2
Connection
- For the crankcase ventilation
- Installed position, refer to Fig 6
O-Ring
- Replacing
- Quantity 2

Fig 2: Locating Throttle Valve Control Module -J338-

Courtesy of AUDI OF AMERICA, LLC

Fig 3: Control Valve Control Unit -J808- - Tightening Specification And Sequence

Courtesy of AUDI OF AMERICA, LLC

Fig 4: Control Valve Control Unit -J808- - Tightening Specification And Sequence

Courtesy of AUDI OF AMERICA, LLC

Fig 5: Identifying Connector -1- & Intake Air Temperature Sensor/Manifold Absolute Pressure Sensor Bolts

Courtesy of AUDI OF AMERICA, LLC

Fig 6: Identifying Installation Of Crankcase Ventilation Connector

Courtesy of AUDI OF AMERICA, LLC