Supercharger, Securing To Engine/Transmission Holder For Leakage Test
NOTE:
The seals on the Gearbox Support Supplement T40206/2 should seal off the openings inside the compressor housing during the leakage test.
Special tools and workshop equipment required
- Engine And Transmission HolderVAS6095
- Gearbox SupportT40206 with T40206/1 and Gearbox Support Supplement T40206/2
Procedure
- Supercharger removed, refer to SUPERCHARGER, REMOVING AND INSTALLING .
-- Install the Gearbox Support T40206 with T40206/1 in the Engine And Transmission Holder VAS6095.
-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1-.
-- Attach the Gearbox Support Supplement T40206/2 directly to the compressor housing at the front and on the right side using the bolt -2-.
Installation position of the Gearbox Support Supplement T40206/2:
- The seals on the supports seal off the openings inside the compressor housing.