Determining CIRCLIP
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert a 1.86 mm thick circlip -A- into groove of input shaft and press upward.
-- Measure dimension between grooved ball bearing -B- and installed circlip -A- using a feeler gauge -C-.
-- Remove circlip inserted for the measurement.
-- Determine the circlip according to the table.
The following locking rings are available:
| Measured Value (mm) | Locking Ring Thickness (mm) | Axial Play (mm) |
|---|---|---|
| 0.01 to 0.05 | 1.86 | 0.01 to 0.05 |
| 0.05 to 0.07 | 1.89 | 0.01 v 0.05 |
| 0.07 to 0.10 | 1.92 | 0.01 to 0.05 |
| 0.10 to 0.13 | 1.95 | 0.01 to 0.05 |
| 0.13 to 0.16 | 1.98 | 0.01 to 0.05 |