Hose/Line Assembly Or Plastic Line

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hose Clamps Up to 25 mm Diameter. 3094

Removing

-- Completely remove the air filter housing. Refer to [For engine(s) CETA, CCTA] Removal and Installation or refer to [For engine(s) CBRA] Removal and Installation or refer to [For engine(s) BPY, CDMA] Removal and Installation .

-- Clamp off the return hose to the clutch master cylinder with a 3094.

Fig 1: Identifying Hose Clamps 3094, Clamp Supply Hose And Master Cylinder

Courtesy of AUDI OF AMERICA, LLC

NOTE:

While performing the following work, make sure that no brake fluid comes into contact with longitudinal member or with transmission. If this happens, these areas must be cleaned thoroughly.

Collect any leaking brake fluid with a cloth.

-- For removal, use a screwdriver to release securing clip -3- on the clutch master cylinder.

Fig 2: Identifying Securing Clip, Hose/Line Assembly & O-Ring

Courtesy of AUDI OF AMERICA, LLC

-- Remove hose/line assembly -1- or plastic line with O-ring -2- and detach from the bracket.

CAUTION:

Do not operate the clutch pedal when the hose/line assembly or plastic line is removed.

NOTE:

Collect any leaking brake fluid with a cloth.

-- For removal, use a screwdriver to release securing clip -2- on the bleeder and remove hose/line assembly -4- or plastic line with O-ring -3- from bleeder -1-.

Fig 3: Identifying Hose/Line Assembly Or Plastic Line On Breather, Removal And Installation

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order, paying attention to the following:

NOTE:

O-rings -2- or sealing rings - differentiation HYDRAULICS ASSEMBLY OVERVIEW

Fig 4: Identifying Securing Clip, Hose/Line Assembly & O-Ring

Courtesy of AUDI OF AMERICA, LLC

-- Check O-ring -2- for damage and replace if necessary.

-- Press hose/line assembly -1- or the plastic line onto clutch master cylinder connection -4- until securing clip -3- engages audibly.

-- Pull on the line to check.

-- Check O-ring -3- for damage and replace if necessary.

Fig 5: Identifying Hose/Line Assembly Or Plastic Line On Breather, Removal And Installation

Courtesy of AUDI OF AMERICA, LLC

-- Press hose/line assembly -4- or the plastic line onto the bleeder connection until securing clip -2- engages audibly.

-- Pull on the line to check.

-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .