Pedal Assembly, Master Cylinder Assembly Overview: Notes
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Grease bearing areas and slide surfaces with grease G 000 450 02.
- Bulkhead
- With mount for mounting bracket
- Gasket
- Replace
- Between the bracket and bulkhead
- Self-adhesive
- Glue on mounting bracket
- Bracket
- For clutch pedal
- Removing and installing, refer to MOUNTING BRACKET
- Bolt
- Over-Center Spring
- Removing and installing, refer to OVER-CENTER SPRING
- Bushing
- Pivot Pin
- Clutch Pedal
- Removing and installing, refer to CLUTCH PEDAL
- In the case of replacement, recut the clutch pedal cap PEDAL ASSEMBLY, MASTER CYLINDER ASSEMBLY OVERVIEW
- Mounting Clip
- For the clutch master cylinder actuator rod
- Oil Seal
- Replace
- Between the clutch master cylinder and bearing bracket
- Clutch Master Cylinder
- Removing and installing, refer to MASTER CYLINDER
- Clutch Position Sensor -G476-
- Removing and installing, refer to CLUTCH POSITION SENSOR
- Check in guided fault finding
- Retaining Clip
- To remove and install the hose/line assembly, pull the clip out to the stop
- Supply Hose
- To brake fluid reservoir
- Made of rubber or plastic depending on the version
- Plastic return hose with additional seals HYDRAULICS ASSEMBLY OVERVIEW
- Nut
- Replace
- 20 Nm
- Self-locking
- Quantity: 3
- For the bracket to the bulkhead
- Nut
- Replace
- 25 Nm
- Self-locking
- End stop
- For clutch pedal