Clutch Position Sensor

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Disconnect electrical connector -4-.

Fig 1: Identifying Hose/Line Assembly

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the clutch position sensor -G476- at the clutch master cylinder in direction of the -arrow- and remove it.

NOTE:

Ignore items -1, 2 and 3-.

Installing

-- Install the clutch position sensor at the clutch master cylinder and engage -arrow-.

Fig 2: Identifying Spring-Type Clamp, Securing Clip, Hose/Line Assembly, Clutch Position Sensor G476 At Master Cylinder & Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Connect harness connector -4-.