LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> TT S, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Clutch - Manual Transmission 02Q (AWD) (Roadster)) >> 30 Clutch >> Description And Operation >> Hydraulics Assembly Overview >> Notes

Hydraulics Assembly Overview: Notes

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Hydraulic System, Assembly Overview
GWWN30-10152Courtesy of AUDI OF AMERICA, LLC
  1. Brake Fluid Reservoir
  2. Spring-Type Clamp
    • Not equipped on all vehicles
  3. Supply Hose
  4. Clutch Master Cylinder
  5. Clip
    • To remove and install the hose/line assembly, pull the clip out to the stop
  6. Sealing Ring or O-ring
    • Replace damaged sealing rings or O-rings
    • Pull onto line connection
    • Install with brake fluid
    • Seals/O-rings suitable for the line connection material HYDRAULICS ASSEMBLY OVERVIEW 
  7. Mounting Clip
    • To remove and install, disconnect the clutch master cylinder from the clutch pedal. Refer to CLUTCH PEDAL 
  8. Clutch Pedal
  9. Nut
  10. Hose/Line Assembly
  11. Bracket
  12. Plastic Line
  13. Bracket
  14. Sealing Ring or O-ring
    • Replace damaged sealing rings or O-rings
    • Pull onto line connection
    • Install with brake fluid
    • Seals/O-rings suitable for the line connection material HYDRAULICS ASSEMBLY OVERVIEW 
  15. Bleeder
  16. Clip
    • To remove and install hose/line assembly or bleeder, pull out clip until stop
  17. Vent Screw
  18. Dust Cap
  19. Clutch Slave Cylinder with Release Bearing
    • Can only be replaced when transmission is removed
  20. Transmission