SUBFRAME Mount, Checking Adjustment

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

-- Pull the Evaporative Emission (EVAP) canister with connected lines upward in direction of -arrow- out of the retainer and lay it aside.

Fig 1: Identifying EVAP Canister

Courtesy of AUDI OF AMERICA, LLC

-- Check dimensions on right mount for engine and transmission:

Fig 2: Checking Dimensions At Engine/Transmission Assembly Mounting

Courtesy of AUDI OF AMERICA, LLC

Both bolt heads -2- must be parallel to edge of engine mount support arm -3-.
A distance of -x- = 16 mm must be present between engine mount -1- and engine support -4-.

NOTE:

Distance -x- = 16 mm can also be checked with corresponding round stock.

-- If distance is too small or too large, subframe mount must be adjusted. Refer to SUBFRAME MOUNT, ADJUSTING .