Right Flange Shaft Seal, Replacing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Thrust piece 3377
Pulling Hook T20143

Removing

Proceed as follows:

NOTE:

Shaft seal can be replaced with transmission installed.
Observe general repair notes. Refer to REPAIR INSTRUCTIONS .
Observe cleanliness rules when working on transmissions. Refer to CLEAN WORKING CONDITIONS .

-- Remove right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Remove shaft seal with T20143/2.

Fig 1: Identifying Flange Shaft With Spring, Thrust Washer And Tapered Ring, Removal

Courtesy of AUDI OF AMERICA, LLC

Installing

-- Drive in new shaft seal as far as stop using T10049.

Fig 2: Driving In New Sealing Ring To Stop Using Thrust Piece T10049

Courtesy of AUDI OF AMERICA, LLC

-- Fill space between sealing and dust lips -arrow- halfway with sealing grease; sealing grease.

Fig 3: Identifying Oil Seals Sealing Lips

Courtesy of AUDI OF AMERICA, LLC

-- Install right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Gear oil level, checking and topping off. Refer to GEAR OIL LEVEL, CHECKING AND FILLING .