Shaft Sealing Ring For Bevel Box With Manual Transmission Installed, Replacing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Oil Collecting and Extracting Device V.A.G 1782
Pulling Hook T20143/2
Thrust Piece T10243

Procedure

The bevel box is removed. Refer to BEVEL BOX, REMOVING .

-- Place drip tray VAS 6208 underneath.

-- Pry the bevel box shaft sealing ring off with the T20143/2 or extractor lever VW 681.

-- Fill space between sealing lip and dust lip -arrow- halfway with sealing grease G 052 128 A1.

Fig 1: Identifying Oil Seals Sealing Lips

Courtesy of AUDI OF AMERICA, LLC

-- Lightly oil outer circumference of new shaft seal.

-- Drive in the shaft sealing ring to the stop.

Fig 2: Carefully Drive In Sealing Ring As Far As Stop Using Thrust Piece T10243

Courtesy of AUDI OF AMERICA, LLC

-- Check the transmission oil level in the manual transmission and fill. Refer to MANUAL TRANSMISSION, CHECKING GEAR OIL LEVEL .