Seal Between Transmission And Bevel Box

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Pulling Hook T20143
Thrust Piece T10298

Procedure

The bevel box is removed. Refer to BEVEL BOX, REMOVING .

-- Pry out sealing ring on bevel box with T20143/1 or T20143/2.

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of AUDI OF AMERICA, LLC

-- Lightly oil outer circumference of new shaft seal.

-- Fill area between sealing lip and dust lip -arrow- halfway with sealing grease G 052 128 A1.

Fig 2: Identifying Oil Seals Sealing Lips

Courtesy of AUDI OF AMERICA, LLC

-- Drive in shaft seal as far as stop with T10298.

Fig 3: Driving In Sealing Ring As Far As Stop Using Thrust Piece T10298

Courtesy of AUDI OF AMERICA, LLC