Ignition System Engine Overview
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition Coils with Power Output Stages
- Cylinder 1 Ignition Coil 1 with Power Output Stage -N70-
- Cylinder 2 Ignition Coil 2 with Power Output Stage -N127-
- Cylinder 3 Ignition Coil 3 with Power Output Stage -N291-
- Cylinder 4 Ignition Coil 4 with Power Output Stage -N292-
- Cylinder 5 Ignition Coil 5 with Power Output Stage -N323-
- Cylinder 6 Ignition Coil 6 with Power Output Stage -N324-
- Removal and installation, refer to IGNITION COILS
- 4-Pin Harness Connector
- For ignition coils with power output stage
- Bracket
- For Knock Sensor (KS) 1 -G61- connector
- Bolt
- 10 Nm
- 3-Pin Harness Connector
- Black
- With gold-plated terminals
- Knock Sensor (KS) 1 -G61-
- Bolt
- 20 Nm
- For trouble-free knock sensor function, it is important to use the exact tightening specifications
- Camshaft Adjuster
- Exhaust side
- With sensor wheel for Camshaft Position (CMP) Sensor 2 -G163-
- After reinstalling, adjust valve timing, refer to Description and Operation
- Camshaft Timing Chain Top Cover
- Removal and installation, refer to Description and Operation
- Seal
- Replace
- Camshaft Position (CMP) Sensor 2 -G163-
- For exhaust camshaft
- Bolt
- 10 Nm
- 3-Pin Harness Connector
- Black
- With gold-plated terminals
- Camshaft Position Sensor -G40-
- For intake camshaft
- Knock Sensor (KS) 2 -G66-
- 2-Pin Harness Connector
- Black
- With gold-plated terminals
- Camshaft Adjuster
- Intake side
- With sensor wheel for Camshaft Position (CMP) Sensor -G40-
- After reinstalling, adjust valve timing, refer to Description and Operation
- Spark Plug
- Current values
- Removal and installation, refer to 810 Service Procedures
- Control Housing
- For camshaft adjustment
- Removal and installation, refer to Removal and Installation