Ignition Coils

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Ignition Coil Puller T10095 A
Assembly Tool T10118

Removing

-- Disconnect electrical harness connectors to ignition coils, to do so attach T10118 on release button -arrow- and carefully disconnect harness connector.

Fig 1: Disconnecting Connector From Ignition Coils 1 To 6

Courtesy of AUDI OF AMERICA, LLC

-- Position T10095 A on ignition coils -arrow- as shown in illustration and remove ignition coils one after another.

Fig 2: Attaching Puller For Ignition Coil T10095 A On Ignition Coils And Pulling Out Ignition Coils In Succession

Courtesy of AUDI OF AMERICA, LLC

Installing

Installation is in reverse order of removal, note the following:

-- Insert ignition coil into corresponding spark plug shaft so that the straight connector sides fit with each other -arrows-.

Fig 3: Identifying Ignition Coil With Power Output Stage

Courtesy of AUDI OF AMERICA, LLC