Fan Shroud

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove bolts -arrows- and remove air duct.

Fig 1: Identifying Bolts -Arrows- And Air Guide

GWWA10-10602

Courtesy of AUDI OF AMERICA, LLC

-- Remove upper fan shroud bolts -top arrows-.

Fig 2: Coolant Fan Control (FC) Control Module J293

GWWA19-0473

Courtesy of AUDI OF AMERICA, LLC

-- Remove noise insulation in center by loosening mounting parts -1 through 4-.

Fig 3: Center Noise Insulation Fasteners And Center Noise Insulation Panel

GWWA10-10600

Courtesy of AUDI OF AMERICA, LLC

-- Remove left and right noise insulation -arrows-.

Fig 4: Remove Right Noise Insulation -Arrows-.

GWWA10-10605

Courtesy of AUDI OF AMERICA, LLC

-- Remove noise insulation frame -arrow-.

Fig 5: Remove Noise Insulation Frame

GWWA10-10604

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect electrical connectors -1- for coolant fan on bottom of fan shroud.

Fig 6: Coolant Fan Control (FC) Control Module J293

GWWA19-0473

Courtesy of AUDI OF AMERICA, LLC

-- Remove fan shroud lower bolts -bottom arrows-.

-- Remove fan shroud downward with both coolant fans.

Installing

Tightening specifications, refer to RADIATOR AND COOLANT FAN ASSEMBLY OVERVIEW .

Installation is in reverse order of removal.