HALDEX-Clutch (Generation HALDEX II), Rear Final Drive 02D/0AV Overview
WARNING: This page is about a different variant/trim than selected.
- Clutch Plate
- Overview, refer to Fig 2
- Removing and installing, refer to FINAL DRIVE 02D AND 0AV, HALDEX CLUTCH GROOVED BALL BEARING
- Bolts
- 6 Nm
- Haldex Clutch Pump -V181-
- Removing and installing, refer to Haldex Clutch Pump -V181-, FINAL DRIVE 02D/0AV
- O-ring
- Always replace
- Diameter 32 mm
- For Haldex clutch pump
- Coat with high performance Haldex clutch oil and insert
- O-ring
- Always replace
- Diameter 30 mm
- For Haldex clutch pump
- Coat with high performance Haldex clutch oil and insert
- Cover
- 35 Nm
- O-ring
- Always replace
- For the sealing cap
- Coat with high performance Haldex clutch oil and insert
- Oil Filter Carrier
- O-ring
- Always replace
- For oil filter carrier
- Coat with high performance Haldex clutch oil and insert
- O-ring
- Always replace
- For oil filter
- Coat with high performance Haldex clutch oil and insert
- Oil Filter
- For Haldex clutch
- No replacement interval
- Removing and installing, refer to FINAL DRIVE 02D AND 0AV, HALDEX CLUTCH OIL FILTER
- Spring
- Haldex Clutch Housing
- Haldex clutch, removing and installing, refer to HALDEX CLUTCH, FINAL DRIVE INSTALLED
- Removing from clutch plate, refer to FINAL DRIVE 02D AND 0AV, HALDEX CLUTCH GROOVED BALL BEARING
- Nut
- 210 Nm
- Secure with locking fluid D 000 600
- Driveshaft Flange
- Removing and installing, refer to REAR FINAL DRIVE FLANGE/DRIVESHAFT SEAL, FINAL DRIVE INSTALLED
- Flange/Driveshaft Sealing Ring
Removing and installing, refer to REAR FINAL DRIVE FLANGE/DRIVESHAFT SEAL, FINAL DRIVE INSTALLED
- Locking Ring
- Ball bearing
- Removing and installing, refer to FINAL DRIVE 02D AND 0AV, HALDEX CLUTCH GROOVED BALL BEARING
- All Wheel Drive (AWD) Control Module -J492-
- With Haldex clutch control valve -N373-
- With oil pressure/temperature sensor -G437-
- Removing and installing, refer to All Wheel Drive Control Module -J492-, REAR FINAL DRIVE 02D/0AV (HALDEX-CLUTCH GENERATION II) OVERVIEW
- Bolts
- 6 Nm
- O-ring
- Always replace
- Coat with high performance Haldex clutch oil and insert
- Clutch Plate
Plates cannot be removed.
- Outer Rollers
Quantity: 3
- Track Rollers
Quantity: 3
Installed position: Roller faces outside
- Track Rollers
Quantity: 3
Installed position: Roller faces inside
- Axial Needle Bearing
The thick disc faces the multidisc clutch -1-.
- Axial Needle Bearing
The thick disc faces the multidisc clutch -1-.
- Axial Needle Bearing
The thick disc faces the multidisc clutch -1-.