All Wheel Drive Control Module -J492-, Rear Final Drive 02D/0AV (HALDEX-Clutch Generation II) Overview
WARNING: This page is about a different variant/trim than selected.
- All Wheel Drive (AWD) Control Module -J492-
- Is calibrated with haldex clutch control valve -N373- List Item:Haldex Clutch Control Valve -N373-
- Always replace together with valve List Item:Haldex Clutch Control Valve -N373-
- Removing and installing, refer to All Wheel Drive Control Module -J492-, REAR FINAL DRIVE 02D/0AV (HALDEX-CLUTCH GENERATION II)
- Bolt
- 6 Nm
- Cover
- Always replace
- With vulcanized seal
- Haldex Clutch Control Valve -N373-
- Is calibrated with AWD control module
- Always replace together with control module List Item:All Wheel Drive (AWD) Control Module -J492-
- Seal
- Redesigned version with diagonal centering lips
- Sealing ring replaced List Item:Seal
- Make sure the centering lip fits correctly in the groove
- Coat with high performance Haldex clutch oil and insert
- Always replace
- Seal
- Old version
- The updated version is contained in the seal set List Item:Seal
- Seal
- Diameter 12 mm
- For Haldex clutch control valve
- Coat with high performance Haldex clutch oil and insert
- Always replace
- Seal
- Diameter 11 mm
- For Haldex clutch control valve
- Coat with high performance Haldex clutch oil and insert
- Always replace
- Seal
- For oil pressure/temperature sensor -G437-
- Coat with high performance Haldex clutch oil and insert
- Always replace
- Oil Pressure/Temperature Sensor -G437-
- Can be reused when replacing control module
- Removing and installing, refer to ALL WHEEL DRIVE CONTROL MODULE -J492-, REAR FINAL DRIVE 02D/0AV (HALDEX-CLUTCH GENERATION II)
- Plate Spring
- In installation position, marking -arrow- must be located at top and face toward pressure sensor, refer to Fig 2.
- Marking -arrow- is located on convex side of plate spring -2-.
- The convex side with the marking -arrow- faces the pressure sensor -1-.
- Marking -arrow- faces upward in installation position.