Input Shaft, Output Shaft, Reverse Drive Gear And Shift Rails/Shift Forks Overview

Fig 1: Identifying Input Shaft, Output Shaft, Reverse Drive Gear & Shift Rails/Shift Forks Overview

Courtesy of AUDI OF AMERICA, LLC

1. Transmission Housing
   • With differential and pinion
2. Input and Output Shafts with Shift Fork Group
   • Disassembling and assembling, refer to SHIFT FORK GROUP, INPUT SHAFT, 1ST, 2ND AND REVERSE GEAR OUTPUT SHAFTS OVERVIEW
3. Oil Catch Tray
   • Gets clipped in to the bearing bracket
4. Reverse Drive Gear
   • With the reverse shaft
   • Reverse drive gear assembly overview; refer to Fig 2
5. Oil Guide Element
6. Magnet
   • Clean off

Fig 2: Reverse Drive Gear Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

1  - Reverse drive gear

Installed position: The shoulder faces the transmission housing.

2  - Needle bearing

3  - Reverse shaft support

4  - O-ring

5  - Reverse shaft

Slide the O-ring onto the circular groove, -arrow- item 4.

The threaded hole on the reverse shaft must line up down the center with the opening on the reverse shaft support.