Vibration Damper, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
Tightening specifications:
- Refer to OVERVIEW - RIBBED BELT DRIVE FOR VEHICLES WITH HYDRAULIC POWER STEERING .
- Refer to OVERVIEW - RIBBED BELT DRIVE FOR VEHICLES WITH ELECTRO-MECHANICAL POWER STEERING .
NOTE:
Replace the bolts that were tightened with an additional turn.
Installation is only possible in one position because of the offset holes.
-- Install the radiator bracket and radiator. Refer to OVERVIEW - RADIATOR/COOLANT FAN .
-- Install the bumper cover end plate. Refer to Removing and Installing .
-- Install the left front coolant pipes. Refer to FRONT LEFT COOLANT PIPES, REMOVING AND INSTALLING .
-- Installing the ribbed belt: