Charge Air Cooler Housing, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Install the Throttle Valve Control Module -J338-, refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .

-- Install the air guides with the screw-type clamps, refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .

-- Connect the coolant hoses with the connector coupling, refer to Fig 1.

Fig 1: Connecting Coolant Hose Coupling

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Do not reuse used coolant.

-- Fill with coolant, refer to COOLANT, DRAINING AND FILLING .

-- Check the oil level, refer to => 410.