LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A5 2.0T >> Repair and Diagnosis >> External Pages >> Different car >> Section 618 (Heating, Ventilation & Air Conditioning (2 Of 2) (As Of 06.2014)) >> 87 Air Conditioning >> Additional Components For Control And Regulation >> Outside Air Temperature Sensor -G17-, REMOVING AND INSTALLING >> Removing and Installing:

Removing and Installing:

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition.

-- Remove the upper lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -E- on the temperature sensor -A- and remove the temperature sensor from the bracket (-B- or -D-).

NOTE:

Depending on the vehicle equipment level, it may be necessary to remove the bumper in order to remove the Outside Air Temperature Sensor -G17- -A- from the bracket -C- installed under the impact member -D- (if, for example, the Outside Air Temperature Sensor -G17- is not accessible from above on vehicles with additional radiators).

-- After installing, check the DTC memory for the Climatronic Control Module -J255- display and control head (and the Instrument Cluster Control Module -J285-) and erase any faults, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding  " function.

scientia non olet · About LEMON Manuals