Overview - Center Differential Housing And Center Differential
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal can also be performed with the transmission installed. Refer to TRANSMISSION, REMOVING AND INSTALLING .
- Bolt
- 24 Nm
- Steel bolts (M8; 63 mm long)
- Quantity: 2
- Center Differential Housing
- With or without vibration dampener, depending on version
- Removing and installing. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Servicing. Refer to OVERVIEW - CENTER DIFFERENTIAL HOUSING .
- Bolt
- 10 Nm + 90° additional turn
- Always replace.
- Aluminum bolts (M8; 42 mm long)
- Quantity: 11
- Pressure Spring
- Plate Spring
- Installed position: The camber on the inner diameter faces the center differential housing
- Shim
- For bearing preloading the ball bearings for the center differential
- Selecting thickness. Refer to BEARING PRE-LOAD, RECALCULATING, CENTER DIFFERENTIAL BALL BEARING .
- Center Differential
- Servicing only by the manufacturer
- Center differential bearing, servicing. Refer to OVERVIEW - SPUR GEAR FOR BEARING AND CENTER DIFFERENTIAL .
- Spacer Sleeve
- Gear Carrier
- Pay attention to the installed position to the transmission cover. Refer to ASSEMBLING TRANSMISSION - Install the Gear carrier -1- on the transmission cover as follows: (See Figure).
- Output Wheel/Drive Wheel
- Transmission Cover / Transmission