Overview - Center Differential Housing
WARNING: This page is about a different variant/trim than selected.
NOTE:
The center differential housing can also be removed and installed while the transmission is installed. Refer to CENTER DIFFERENTIAL HOUSING, REMOVING AND INSTALLING
- Center Differential
- Servicing only by the manufacturer
- Pressure Spring
- Shim
- for bearing preloading the ball bearings for the center differential
- Selecting thickness. Refer to BEARING PRE-LOAD, RECALCULATING, CENTER DIFFERENTIAL BALL BEARING .
- Plate Spring
- Installed position: the camber on the inner diameter faces toward the flange shaft
- Spacer Sleeve
- Circlip
- For the flange shaft
- Removing and installing. Refer to Figure.
- Ball Bearing
- Shaft Seal
- Rear Flange Shaft
- Rear Flange Shaft
- Bolt
- 24 Nm
- for vibration damper
- Quantity: 3
- install with Locking Fluid AMV 185 101 A1
- Vibration Damper
- Not present on all versions
- Allocate according to transmission code.
- Center Differential Housing
- Removing and installing on installed transmission. Refer to CENTER DIFFERENTIAL HOUSING, REMOVING AND INSTALLING