Overview - Cylinder Block, Transmission Side
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For Assembly Work, Secure The Engine On The Engine And Gearbox Bracket VAS6095A :VAS6095A . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Bolt
- 60 Nm + 90°
- Replace after removing
- Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the torque converter holes for cracks and signs of wear.
- Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Removing and installing. Refer to SENSOR WHEEL, REMOVING AND INSTALLING .
- Checking. Refer to SENSOR WHEEL, CHECKING .
- Seal
- For the crankshaft on the transmission side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Crankshaft
- Alignment Pin