LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 962 (Climate Control System (Service Information - (Front Heater & A/C Unit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Front Heater And A/C Unit >> Fresh Air Blower -V2-, REMOVING AND INSTALLING >> Fresh Air Blower -V2- WITH Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING >> Installing

Fresh Air Blower -V2- WITH Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Installation is done is reverse order, observe the following:

-- Tighten the bolts to the tightening specification. Refer to OVERVIEW - HEATER AND A/C UNIT AIR INTAKE HOUSING .

After completing the repair work, perform the following operations on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding"  function:

-- Check the Diagnostic Trouble Code (DTC) memory and delete any currently displayed entries.

-- Perform the basic setting.

-- Perform output Diagnostic Test Mode (DTM)

scientia non olet · About LEMON Manuals