Engine Mount, Removing And Installing: Removing: Notes

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the engine in its installed position. Refer to ENGINE, SUPPORTING IN INSTALLED POSITION .

-- Remove the noise insulations. Refer to NOISE INSULATION .

-- Remove the corresponding front wheel spoiler. Refer to WHEEL HOUSING LINER .

Left Engine Mount

Courtesy of AUDI OF AMERICA, LLC

-- If equipped, remove the nuts -arrows- and move the bracket -1- to the side.

-- Remove the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Risk of damaging refrigerant lines and hoses.

Do not stretch, kink or bend refrigerant lines and hoses.

-- Remove the bolts -arrows-.

-- If applicable, remove bracket -1-.

-- Remove the Air Conditioning (A/C) compressor from the bracket and tie it up.

-- If equipped, loosen the left and right nuts -arrows- on the crossbrace. Leave the crossbrace -1- in its installed position.

Courtesy of AUDI OF AMERICA, LLC

-- If present, remove the bolts -arrow-, Press stop -1- for the torque support towards the engine.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left subframe bolt -2-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The left subframe bolts -1 and 3- and all the right subframe bolts remain installed.