Engine, Supporting In Installed Position
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Support Bridge :10-222A
- Engine Support Bridge - Spindle :10-222A/11
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Remove the left and right foam block -arrow-.
-- Position the :10-222A on the left and right suspension strut towers as illustrated.
CAUTION:
Danger of causing damage to the turbocharger assembly on BiTurbo Engines.
- The spindles on the engine support bridge should only be attached to the engine lifting eyes and never engaged in the turbocharger assembly lifting eyes.
-- Engage the :10-222A/11 in the left and right engine lifting eyes.
-- Lightly pretension engine with spindles.