Tie Rod End, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Mount the tie rod head -1- on the tie rod -2- until dimension -a-, which was measured during removal, is reached.

Courtesy of AUDI OF AMERICA, LLC

-- Align the tie rod head -1- so that the pin is in the installation position.

-- Insert the tie rod end into the wheel bearing housing as far as the stop.

-- Tighten the nut -1-. Counterhold when tightening.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -2-

Courtesy of AUDI OF AMERICA, LLC

-- Install the front wheel. Refer to WHEELS AND TIRES .

-- Axle alignment. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .

The axle alignment must be performed on a VW/Audi approved alignment stand.