LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 946 (Wheels, Tires, Wheel Alignment & Collision Avoidance System (General & Service Information)) >> Wheels, Tires, Wheel Alignment >> Vehicle Alignment >> Evaluating Need For Axle Alignment

Evaluating Need For Axle Alignment

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
A Component on the Front Axle Was Replaced: Wheel Alignment Check Required A Component on the Rear Axle Was Replaced: Wheel Alignment Check Required
  Yes No   Yes No
Upper rear control arm   X Shock Absorber   X
Upper front control arm   X Upper Transverse Link X  
Lower guide control arm   X Lower transverse link X  
Lower track control arm   X Bonded rubber bushing   X
Ball Joint   X      
Air spring damper/steel spring damper   X Air spring/coil spring   X
Shock absorber fork   X      
Wheel bearing housing   X Wheel bearing housing X  
Tie rod X   Tie rod X  
Tie rod end X        
Steering Gear X        
Subframe X   Subframe X 1)  
Stabilizer Bar   X Stabilizer Bar   X
Coupling rod   X Coupling rod   X
  • 1) Even if the subframe was secured with the :T40242  , an axle alignment may be necessary. Perform a road test. Refer to SUBFRAME, SECURING, FWD .