LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 936 (Suspension System (Front - Service Information)) >> Front Suspension >> SUBFRAME >> SUBFRAME With Steering Gear, Removing And Installing >> Installing >> Notes

SUBFRAME With Steering Gear, Removing And Installing: Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

WARNING:

Pull on the -Item 1- OVERVIEW - STEERING COLUMN, POWER steering intermediate shaft to make sure it is installed correctly with the bolt installed. Tighten the bolt -Item 1- OVERVIEW - STEERING COLUMN, POWER .

NOTE:

Perform a pre-adjustment on the subframe if it is being replaced or if it had to be removed in order to loosen the crossbrace.

scientia non olet · About LEMON Manuals