Overview - Steering Column, Power
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 30 Nm
- Always replace if removed
- The threaded hole for the bolt must always be cleaned (for example, using a thread tap).
- Install the bolt first, then pull on the steering intermediate shaft several time to make sure it is secure. Tighten the bolt.
- Steering Intermediate Shaft
- Removing and installing. Refer to STEERING INTERMEDIATE SHAFT, REMOVING AND INSTALLING .
- Pay attention to the installed position of the sealing boot
- Power Adjustable Steering Column Control Module -J866-
- Removing and installing. Refer to Power Adjustable Steering Column Control Module -J866-, REMOVING AND INSTALLING .
- Instrument Panel Crossmember
- Bolt
- Tightening specification. Refer to INSTRUMENT PANEL CROSSMEMBER .
- Mounting Bracket
- Removing and installing. Refer to Instrument Panel .
- Bolt
- 5 Nm
- Bolt
- 5 Nm
- Electronic Steering Column Lock Control Module -J764-
- Removing and installing. Refer to Electronic Steering Column Lock Control Module -J764-, REMOVING AND INSTALLING .
- Installed on vehicles with lock lock-up system
- If the control module is being replaced, then select "replace" control module on the Vehicle Diagnostic Tester in Guided Functions .
- Bolt
- 20 Nm
- Quantity: 2
- Follow the assembly sequence when installing. Refer to Installing - Follow the Assembly Sequence when Installing ..
- Bolt
- 20 Nm
- Quantity: 2
- Follow the assembly sequence when installing. Refer to Installing - Follow the Assembly Sequence when Installing ..
- Steering Column
- There are different versions. For the correct allocation. Refer to the parts information.
- Calibrate after replacing the steering column on a vehicle with dynamic steering. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing. Refer to STEERING COLUMN, REMOVING AND INSTALLING .
- Check for damage. Refer to STEERING COLUMN, CHECKING FOR DAMAGE .
- Bolt
- For attaching the pedal assembly
- Tightening specification. Refer to appropriate service information. .
- Bolt
- 20 Nm
- Quantity: 2
- Follow the assembly sequence when installing. Refer to Installing - Follow the Assembly Sequence when Installing .
- Bolt
- 30 Nm
- Always replace if removed
- The threaded hole for the bolt must always be cleaned (for example, using a thread tap).
- Nut
- 3 Nm