Solenoid Valve Block, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Solenoid Valve Block Is Located On The Air Supply Unit.

-- Place the vehicle on a hoist. Refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .

-- Vent the system. Refer to SYSTEM, VENTING OR FILLING .

-- Turn off the ignition.

-- Remove The Luggage Compartment Floor Covering. Refer to LUGGAGE COMPARTMENT FLOOR, REMOVING AND INSTALLING or remove the spare tire.

NOTE:

Make Sure No Dirt Gets Into The Pressure Air System.

Clean The Area Before Removing Connecting Pieces For The Air Pipe Lines Or Other Components Of The Pressured Air System.

Seal Off Any Open Air Lines And Connections In The Pressure System Immediately With Plugs Or Cover Them.

-- Disconnect the connector -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air lines -arrows- and protect them immediately from dirt.

-- Remove the solenoid valve block -1-.