Level Control System Solenoid -N111-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal. Note The Following:
NOTE:
The Vehicle May Be Removed From The Vehicle Hoist Only After The Air Springs Have Been Filled Again. Refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .
Make sure the positioning pin on the air spring is installed correctly inside the body before filling the air suspension system. The air spring must be locked secure inside the wheel bearing housing at the same time. Refer to the image below. .
NOTE:
Always Replace The O-Rings.
-- Coat the new O-rings -1 and 4- with the supplied grease.
- Note the anchor installation position -2-. The chamfer must point toward the spring -3-.
- Do not tilt the Level Control System Solenoid -N111- when installing it and when tightening the bolts.
-- Air suspension system, filling SYSTEM, VENTING OR FILLING .