Rear Axle

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Before lifting the suspension, the vehicle must secured to the lifting arms on the hoist -arrow B- using the :T10038 over the striker pin -arrow A-.

Courtesy of AUDI OF AMERICA, LLC

-- Place a piece of foam rubber -1- between the sill panel and the :T10038 and then tension the :T10038 .

NOTE:

Be careful not to scratch the sill panel.

CAUTION:

The Vehicle Could Fall off the Hoist If It Is Not Secured.

-- Place vehicle on hoist. Refer to RAISING AND LOWERING WITH OPEN AND CLOSED AIR SUSPENSION SYSTEM .

-- Remove the air suspension system. Refer to SYSTEM, VENTING OR FILLING .

-- Remove the wheel. Refer to WHEELS AND TIRES .

-- Turn the wheel hub until one of the holes for the wheel bolts is on top.

Courtesy of AUDI OF AMERICA, LLC

-- Install :T10149 with wheel bolt.

-- Insert :T10149 into :VAS6931 and press wheel bearing housing far enough upward until control position, dimension -a-, is obtained.

Dimension -a- is dependent on standing height of installed suspension: