LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Suspension System (Rear - Service Information)) >> 42 Rear Suspension >> Drive Axle >> Drive Axle, Removing And Installing >> Installing

Drive Axle, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

-- Install the rear final drive. Refer to FINAL DRIVE [For transmission(s) 0BK] .

-- Install the speed sensor. .

-- Install rear wheel. Refer to WHEELS AND TIRES .

-- Fill the rear axle air springs. Refer to SYSTEM, VENTING OR FILLING .

-- Tighten the drive axle to wheel hub threaded connection. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

scientia non olet · About LEMON Manuals