Overview - Front Brakes, Steel Brakes, 1LF/1LL/1ZK/Fm0

Refer to BRAKE SHIELD, REMOVING AND INSTALLING 

• For brake hose and wire

• 9 Nm

• 196 Nm
• Replace after removing
• With a washer
• Quantity: 2

• 20 Nm (brake hose to brake caliper)
• Replace if damaged
• Pay attention to the correct routing: make sure the brake hose is not blocked, bent or rubbing against the vehicle
• Make sure that tabs are properly seated in the grooves on the bracket.

• For brake hose

• Replace if damaged

• 16 Nm (brake line to brake hose)

• Quantity: 2

• Allocation. Refer to the parts information.
• Inner brake pad with brake pad wear sensor
• Checking pad thickness. Refer to appropriate service information.
• Always replace on both sides of the axle

  Refer to BRAKE PADS, REMOVING AND INSTALLING 

• 55 Nm
• Seal with a protective cap

• Left Front Brake Pad Wear Sensor -G34- /Right Front Brake Pad Wear Sensor -G35-
• For inner brake pad
• Replace if damaged
• Refer to BRAKE PAD WEAR INDICATOR WIRE, REMOVING AND INSTALLING, STEEL BRAKES, 1LF/1LL 

• 13 Nm
• Refer to HYDRAULIC SYSTEM, BLEEDING

• Allocation. Refer to the parts information.

  Refer to BRAKE CALIPER, REMOVING AND INSTALLING 

  Refer to BRAKE CALIPER, REPLACING 

• Servicing. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING, 1LF/1LL .
  NOTE:

  Depending on the model there are two balance weights installed in each front brake caliper.

  Refer to OVERVIEW - BRAKE CALIPER BALANCE WEIGHT 

• Make sure the cover and balance spring are installed correctly
• Tab of the balance spring engages into the brake caliper
• Tip of the balance spring fits under the trim

• Make sure the cover and balance spring are installed correctly
• Tip of the balance spring fit into the brake caliper
• Tip of the balance spring fits under the trim

• 22 Nm

• Allocation. Refer to the parts information.
• Wear limit. Refer to TECHNICAL DATA, BRAKES
• Always replace on both sides of the axle

  Refer to BRAKE ROTOR, REMOVING AND INSTALLING 

• Do not use force to separate the brake rotor from the wheel hub. If required use rust remover otherwise there will be damage to the brake rotors

• 10 Nm

• Bolt to wheel bearing housing
• Brake Caliper with Brake Carrier, removing and installing. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, STEEL BRAKES, 1LF/1LL .

• 10 Nm
• Quantity: 4