Brake Pads, Removing And Installing, Steel Brakes, 1LF/1LL: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

-- When the brake pads are replaced, check the brake rotors for wear and damage:

Brake rotor wear limit. Refer to TECHNICAL DATA, BRAKES .

NOTE:

Always replace brake pads on both sides of the axle.

Use the complete repair kit when installing new brake pads.

WARNING:

Health Risk.

Do not blow out brake system with compressed air.

NOTE:

Use only mineral spirits to clean the brake caliper.

Check the brake caliper piston protective caps for damage and install the complete repair kit, if necessary. Refer to BRAKE CALIPER PISTON, REMOVING AND INSTALLING, 1LF/1LL .

CAUTION:

There is a risk of contamination and paint damage from escaping brake fluid.

If the brake pads are worn out and brake fluid is filled unnecessary, the brake fluid may overflow, causing the pistons in the brake cylinders to be pressed back.
Check the brake fluid level before pressing back the pistons. If there is brake fluid up to the "MAX" mark, some brake fluid will need to be extracted.
Use the :VAS5234 to extract brake fluid from the brake fluid reservoir.

-- Use the :T10145 to press the brake caliper piston completely back into the brake caliper.

-- Clean the brake caliper.

-- Clean the brake carrier on the contact surfaces -1 and 2- to the brake pads.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If there is grease residue on the brake rotor clean it with brake cleaner.

-- If reusing, install the marked brake pads in the same location.

Courtesy of AUDI OF AMERICA, LLC

-- Clip the inner brake pad -A- into the brake caliper piston.

-- Clip the outer brake pad -B- into the brake caliper.

-- Slide the brake caliper with the brake pads installed carefully over the brake rotor.

-- Tighten the guide pins -2- and press on the protective caps -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Engage the brake hose -1- at the bracket.

NOTE:

Check the contact for the brake pad wear sensor for damage, replacing if necessary.

Make sure that the brake pad wear sensor contact sits correctly in the brake pad.

Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.

Make sure the protective caps for the guide pins are not damaged.

Make sure the protective caps are installed properly.

-- Install the contact -1- for the brake pad wear sensor. Refer to BRAKE PAD WEAR INDICATOR WIRE, REMOVING AND INSTALLING, STEEL BRAKES, 1LF/1LL .

-- Bring the balance spring -1- and trim -2- into its installed position and tighten the bolt -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the front wheel. Refer to WHEELS AND TIRES .

WARNING:

Risk of accident!

With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.
Make sure the brakes are working correctly before driving the vehicle for the first time.

-- Check brake fluid level, and fill if necessary.