Overview - Final Drive 0BC, 0BD: Notes

WARNING: This page is about a different variant/trim than selected.

Rear Final Drive

Fig 1: Overview Of Final Drive 0BC, 0BD

Courtesy of AUDI OF AMERICA, LLC

Subframe
- Removing and installing. Refer to OVERVIEW - SUBFRAME .
Bolt
- 95 Nm
Bolt
- 55 Nm
Bolt
- 55 Nm
- Depending on the date of manufacture for the balance weight fastener. Refer to OVERVIEW - FINAL DRIVE 0BC, 0BD - BALANCE WEIGHT ON THE REAR FINAL DRIVE .
Heat Shield
Bolt
- 20 Nm
Driveshaft
- Removing and installing. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
Rear Final Drive
- Versions with balance weight. Refer to OVERVIEW - FINAL DRIVE 0BC, 0BD - BALANCE WEIGHT ON THE REAR FINAL DRIVE .
- Refer to FINAL DRIVE, REMOVING AND INSTALLING
Driveshaft
- Removing and installing. Refer to DRIVESHAFT, REMOVING AND INSTALLING .
- Removing and installing on the rear final drive. Refer to DRIVESHAFT, REMOVING AND INSTALLING FROM REAR FINAL DRIVE .
Crossmember