Gear Oil, Checking Level, Front Final Drive

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Procedure

Gear oil temperature at approximately 20 °C (68 °F) (room temperature).
Move the vehicle onto a 4-column shop hoist or over a work pit so it is completely level.
Tightening specification. Refer to OVERVIEW - FINAL DRIVE .

NOTE:

General repair instructions. Refer to GENERAL REPAIR INFORMATION .

Clean working conditions for the automatic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Always maintain the specified transmission fluid level. The transmission is very sensitive to overfilling.

Follow all applicable disposal regulations.

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

WARNING:

Danger of eye injury.

-- Remove the plug -arrow-.

Fig 1: Gear Oil Level In Front Final Drive, Checking And Filling

Courtesy of AUDI OF AMERICA, LLC

Specified value: the oil level is correct when the front final drive is filled to the lower edge of the filler hole.

-- Allow the excess gear oil to drain if necessary.

-- Add gear oil if necessary until it runs out of the gear oil filler hole.

NOTE:

Replace the drain plug and gasket.

-- Tighten the new sealing plug.